[REQ_ERR: 404] [KTrafficClient] Something is wrong. Enable debug mode to see the reason.
Water level indicator project using 8051
AdRed-Green Light Indicators, Measures 10k -1Meg Ohm/cm Resistivity. Components Required for Water Level Controller using Microcontroller · AT89C51 Microcontroller (or any based Microcontroller) · 20 մրտ, թ. On YouTube you can find the best Videos and Music. . Search results for „water level indicator project using “. You can upload your own videos and share them with your friends and family, or even with the whole world. MOV P2,#B // initiates P2 as sensor input MOV P0,#B // initiates P2 as the output port MOV A,#B MAIN:ACALL SMPCK // checks the level of the sump tank MOV A,P2 // moves the current status of P2 to A CJNE A,#B,LABEL1 // checks whether tank is full SETB P SETB P SETB P Water level controller using Program. Water level controller using Program. MOV P2,#B // initiates P2 as sensor input MOV P0,#B // initiates P2 as the output port MOV A,#B MAIN:ACALL SMPCK // checks the level of the sump tank. Circuit diagram. The circuit diagram of the water level controller is shown in the figure below. AdIndustrial, Non-Contact ultrasonic, see Level & Volume, just install, and turn power ON. This project water level indicator circuit typically works on the basic take their output on the microcontroller ports by using jumper wires P